Table of Contents
Advertisement
General configuration
Changing hotkeys
AV4PRO-DP units use
and
changed if they clash with other software or hardware within the installation.
To change the hotkeys
Configuration
1 Enter the
menu.
2 Press
to enter the Hotkey menu and then press either:
to choose Ctrl + Alt
to choose Ctrl + Shift
to choose Alt + Shift
to choose Right Alt
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
to exit the menu and save changes.
Mouse switching
You can enable or disable mouse switching to suit your installation requirements.
To enable/disable mouse switching
1 Enter the
Configuration
menu.
to enter the User Preferences menu and then press either:
2 Press
to Enable mouse switching
to Disable mouse switching
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
to exit the menu and save changes.
as their standard hotkeys. These can be
to choose Alt
to choose Left Ctrl + Alt
to choose Right Ctrl + Alt
to disable the Hotkeys
OPTIONS port speed
You can change the speed of the OPTIONS serial port.
To change the OPTIONS port speed
1 Enter the
Configuration
menu.
to enter the Baud rate menu and then press either:
2 Press
to choose 1200
to choose 2400
to choose 9600
to choose 19200
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
to exit the menu and save changes.
OPTIONS port channel control behaviour
You can determine how the OPTIONS port responds to channel control inputs.
To define the OPTIONS port behaviour
Configuration
1 Enter the
menu.
2 Press
to enter the Options port menu and then press either:
to allow channel switching commands to be received via RS-232 serial
signal through the OPTIONS port (see
details and
Channel switching by external control
details). The baud rate currently set by the
port. Switching commands via the four channel select inputs within the
OPTIONS port connector are disabled in this mode. Use option
wish to enable the channel select inputs in addition to RS-232 control.
to allow channel switching commands to be received from the optional
Optional RC4 control
RC4 remote control (see
The baud rate set by the
RC4 is automatically imposed. Switching commands via the four channel
select inputs within the OPTIONS port connector are disabled in this mode.
enables channel switching via RS-232 as per option
mode the four channel select inputs are also enabled.
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
to exit the menu and save changes.
to choose 38400
to choose 57600
to choose 115200
Appendix 1
for cable pin-out
for command
option will be used for the
for connection details).
option is ignored and the rate used by the
. However, in this
continued
if you
13
Advertisement
Table of Contents
