Table of Contents
Advertisement
Switching mode
Using the configuration menu, you can define a default switching mode.
The switching mode determines which peripherals (KVM, USB1, USB2 and/or
speakers) should be moved to the next computer when it is selected using any
of the standard methods. Regardless of the default switching mode set here,
during use you can always change the mode using either the MODE button (on
the front panel) or using the additional hotkey press combinations.
Note: Of the external switching methods, the RC4 remote and the RS-232 serial
signal inputs will switch the peripherals as defined by the currently selected
switching mode. However, switching control initiated by the channel select input
lines will always switch all of the peripherals to the chosen channel regardless of
the switching mode.
To set the default switching mode
1 Enter the
Configuration
menu.
2 Press
to enter the Switch Mode menu and then press either:
to select All
(default)
to select KVM and speaker
to select KVM only
to select Speaker only
to select USB1 only
to select USB2 only
3 Press
to accept the setting and return to the main menu section.
4 Press
and then
to exit the menu and save changes.
Miscellaneous functions
To reset configuration to factory defaults
Configuration
1 Enter the
menu.
to enter the Functions menu
2 Press
3 Press
and then
. The display will show
4 Press
and then
to exit the menu and save changes.
To show the current firmware version
Configuration
1 Enter the
menu.
2 Press
to enter the Functions menu
3 Press
and then
.
The display will blank for a short while and then the major number of the
firmware revision will be shown. The display will blank again and then show
the first digit of the minor number. Following another blank, the second
digit of the minor number will be displayed. e.g. <blank> 1 <blank> 0
<blank> 2 <blank> equals v1.02
4 Press
and then
to exit the menu and save changes.
To set a new password
Configuration
1 Enter the
menu.
2 Press
and then
. The display will show
3 Enter a new password and then
4 Press
and then
to exit the menu and save changes.
momentarily.
. See
To lock access to the
computers.
14
Advertisement
Table of Contents
