Enabling Dhcp - D-Link DFL-260E User Manual

3.3.2. Ethernet Interfaces
UserAuthGroups:
NoDefinedCredentials:
By using the tab key at the end of a line, tab completion can be used to complete the command:
gw-world:/> show Address IP4Address InterfaceAddresses/wan_<tab>
[<Category>] [<Type> [<Identifier>]]:
InterfaceAddresses/wan_br
InterfaceAddresses/wan_dns1
InterfaceAddresses/wan_dns2
Here, tab completion is used again at the end of the command line:
gw-world:/> set Address IP4Address<tab>
[<Category>] <Type> [<Identifier>]:
dnsserver1_ip
InterfaceAddresses/aux_ip
InterfaceAddresses/aux_net InterfaceAddresses/wan_dns2
InterfaceAddresses/dmz_ip
InterfaceAddresses/dmz_net InterfaceAddresses/wan_ip
InterfaceAddresses/lan_ip
InterfaceAddresses/lan_net Server
Setting Interface Addresses
The CLI can be used to set the address of the interface:
gw-world:/> set Address IP4Address
Modified IP4Address InterfaceAddresses/wan_ip.

Enabling DHCP

The CLI can be used to enable DHCP on the interface:
gw-world:/> set Interface Ethernet wan DHCPEnabled=yes
Modified Ethernet wan.
Ethernet Device Commands
Some interface settings provide direct management of the Ethernet settings themselves. These are
particularly useful if D-Link hardware has been replaced and Ethernet card settings are to be
changed, or if configuring the interfaces when running NetDefendOS on non-D-Link hardware.
For example, to display all Ethernet interface information use the command:
gw-world:/> show EthernetDevice
This command shows lists all Ethernet interfaces. Those defined as logical interfaces in the current
configuration are marked by a plus "+" symbol on the left of the listing.
Address: 0.0.0.0
<empty>
No
Comments: Default gateway for interface wan
InterfaceAddresses/wan_br timesyncsrv1_ip
InterfaceAddresses/wan_dns1
InterfaceAddresses/wan_gw
InterfaceAddresses/wan_net
InterfaceAddresses/wan_ip Address=172.16.5.1
100
InterfaceAddresses/wan_gw
InterfaceAddresses/wan_ip
InterfaceAddresses/wan_net
Chapter 3. Fundamentals