Garrett CS 5000 User Manual page 21

Included in the test procedure should be the requirement that the tester be free of all metallic items,
including shoe shanks, prior to arming himself with the OTP. A hand-held metal detector can be used
to confirm that the tester is "clean" of extraneous metallic items.
7.4 ANKLE BOOST
The CS 5000 (Version 2.60 or greater, as displayed in Self-Test, Page 10) incorporates the ability to
adjust the sensitivity at ankle level without increasing sensitivity throughout the passageway. The fac-
tory setting is with standard ankle boost to allow easier passage of shoes containing metal shanks.
Two additional levels of boost are available for higher levels of security.
This adjustment should be used only when sensitivity at ankle level needs to be increased.
7.4.1. PROCEDURE:
• Disconnect the unit from AC power source (switch off battery back-up module, if installed
• Open access door of detection unit;
• Remove the three (3) screws that hold the controller cover. Move jumpers as shown in the above
diagram to achieve the required level of boost (both jumpers must be set to the same level);
• Replace cover and reconnect power;
• Test unit to assure desired performance level.
7.4.2. APPLICATIONS:
• high: High sensitivity; low traffic volume
• Medium: High Sensitivity; high traffic volume
• Standard: Normal sensitivity; high traffic volume
©2009 GARRETT METAL DETECTORS
CS 5000
User Manual
21 PN 1530100 REV H