Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Garrett Pro-Pointer AT 1140900
Summary of Contents for Garrett Pro-Pointer AT 1140900
- Page 1 ®...
- Page 2 FEATURES ON/OFF, Retune, Adjust Button Pinpointing Tip 360° Side-Scan Area Exclusive Scraping Blade LED Flashlight Waterproof Speaker Lanyard Attachment Loop Sealed Battery Cover Ruler in Inches and Centimeters (Reverse side of pinpointer) ...
- Page 3 Powering On Press and release the button ( ) while holding the detector away from any metallic objects. You will hear 2 beeps and the LED ( ) will remain on. Powering Off Press and hold the button for a half second until you hear a single beep (or single vibration in Silent Mode), indicating power down.
- Page 4 Notes: • Lower Sensitivity settings are recommended to prevent detection of highly mineralized grounds. • Detection remains operable during the adjustment mode. • Settings will be remembered when the unit is switched off and back on. Fast Retune for Mineralized Ground To tune out the detection of saltwater, wet sand or highly mineralized ground, hold the tip of the Pro-Pointer AT to the water, sand or soil and quick-press the button (...
- Page 5 Lost Pinpointer Alarm After 5 minutes of being ON without a button press, the Pro-Pointer AT will begin emitting progressively faster warning chirps for 60 minutes. Press the power button to reset. Auto-Off Feature After one hour of warning chirps, the Pro-Pointer AT will power off automatically.
-
Page 6: Battery Replacement
Ruler The Pro-Pointer AT has a ruler molded into its exterior to measure a target’s depth in either centimeters or inches. Low Battery Alarm When the battery becomes low, the detector will sound an alternating dual-tone alarm. Replace the 9V battery as soon as possible. Battery Replacement Simply rotate the battery cover counterclockwise to remove and clockwise to tighten by hand. - Page 7 • Because the AT is a static, non-motion detector, optimum Pro-Pointer operation is achieved when the unit is switched off between uses. • Avoid using the Pro-Pointer AT as a digging or prying tool. It is designed for flat side-scanning and precise pinpointing with its tip. It is not intended to be used with excessive force.
-
Page 8: Specifications
MADE IN THE USA The Garrett Pro-Pointer AT is manufactured in the United States of America and in accordance with Garrett’s ISO 9001 internationally certified Quality Management System and meets the following international standards: • FCC • CE • RoHS •...