Download Print this page

Inglis IES356RD1 Installation Instructions Manual page 5

30" (76 cm) freestanding electric range
Hide thumbs Also See for IES356RD1:

Advertisement

Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket,
if the range is moved.
Failure to fellow these instructions can result in death
or serious burns to children and adults.
Contact a qualified floor covering installer for the best procedure
for drilling mounting holes through your type of floor covering.
Before moving range, slide range onto shipping base, cardboard
or hardboard.
f.
Remove template from the anti-tip bracket kit (found inside
the oven cavity) or from the back page of this manual.
2. Place template on the floor in cabinet opening so that the left
edge is against cabinet and top edge is against rear wall,
molding or cabinet.
3. Tape template into place.
4. If countertop is not flush with cabinet opening edge, align
template with overhang.
If cabinet
opening is wider than that specified
in the "Location
Requirements"
section,
adjust template
so range will be
centered
in cabinet opening.
5. To mount anti-tip bracket to wood floor, drill two %" (3.2 mm)
holes at the positions marked on the bracket template.
Remove template from floor.
6=
7.
To mount anti-tip bracket to concrete or ceramic floor, use a
3/16"(4.8 mm) masonry drill bit to drill 2 holes at the positions
marked on the bracket template. Remove template from floor.
Tap plastic anchors into holes with a hammer.
Align anti-tip bracket holes with holes in floor. Fasten anti-tip
bracket with screws provided.
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
8. Move range close to opening. Remove shipping base,
cardboard or hardboard from under range.
9. Connect power supply cord as described in the "Electrical
Connection"
section.
fO. Move range into final position making sure rear leveling leg
slides into anti-tip bracket.
11. Continue installing your range using the following the
installation instructions.

Advertisement

loading