Jenn-Air JUD278DBCX00 Installation Manual page 8

2. Proceed slowly from corner to corner until the gasket is
completely free from the groove.
3. Gently push the gasket to the back of the drawer. Be sure to
keep all screws and loose metal parts away from the
magnetic gasket as shown.
II
A B
A. Drawer front
B. Gasket
4. Repeat the process for the other gasket.
Install the Custom Overlay Panels
IMPORTANT:
• Before installing the custom overlay panels, be sure to install
any custom hardware. See "Hardware Installation (optional)."
• Be sure to maintain a 3/8"(9.52 ram) gap between the overlay
panel (top drawer) and the bottom of the kitchen cabinet.
1. Using a Phillips screwdriver or scribe, remove any residual
foam from the pre-drilled pilot holes.
A ....
A
A. Pre-drilled pilot holes
..... A
2.
3,
4,
5,
Using a Phillips screwdriver, remove the wiring plug cover for
the upper drawer as shown. Do not discard the screw or
cover. Set them aside for later use.
NOTE: Removing the wiring plug cover will allow for easier
access when drilling and attaching the drawer front to the
overlay panel. Be sure to replace the wiring plug cover when
installation is complete.
A. Wiring plug cover
B. Screw
Remove the backing from the double-sided tape. Install the
overlay panel to the drawer front. Be sure to align all edges of
the drawer front to the overlay panel. Be sure that the overlay
panel is level.
NOTE: The tape will secure the panel in place while drilling
the pilot holes.
A. Double-sided tape
Using the pre-drilled holes in the drawer front as a guide, use
a scribe to mark the drilling locations on the overlay panel.
Drill six 1/s"diam. x 1/2"deep (3.18 mm x 12.7 mm) holes into
the overlay panel.
IMPORTANT: Do not drill deeper than 1/2"(12.7 mm).
Drive six #8 x 1/2"pan-head screws through the drawer front
into the overlay panel.