Kenmore 79075922300 Installation Instructions Manual page 6

Operation of Surface Burners
6. Installation of Surface Burner Caps
Your range is equipped with any combination of the sealed
burners. Refer to the illustration below to find your surface
burner and surface burner cap configuration. Be sureto place
the correct burner cap at on all four surface burners.
.... _ii ii i_ _ ...... _ii
7. Electric Ignition Surface Burners
Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power.
a. To check for proper lighting, push in and turn a surface
burner knob counterclockwise to the UTE position.
You will hear the igniter sparking (see illustration below).
b,
The surface burner should light when gas is available to
the top burner. Purge air from supply lines by leaving
knob in the UTE position until burner ignites. Each
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
c. Visually check that burner has lit. Once the burner lights,
the control knob should be turned out of the LITE position.
d. There are separate electrodes (igniters) for each burner.
Try each knob separately until all burner valves have
been checked.
Possible Surface Burner and Cap configurations
Install the parts illustrated below at all four surface burner
locations:
1st - Install the surface burner pans (if equipped);
2nd -install the surface burner heads;
3rd - install the surface burner caps and
4th;install the burner grates.
Surface
Burner
Grate
==========
n%Ce
Cap
Note: Knob styles and colors may vary from that pictured.
..... !!i!ii!!i_,,
.......... iiii!i!ii ili i
Orifice I
Hole
j-
Removable
Burner
Drip Pan
(on some models)