Table of Contents
Advertisement
4-7. See-through Sensor on/off
There are two types of sensor in Falcon 4D Plus printer - Reflective Sensor and See-through
Sensor. Users can set one of them as active sensor. By default, the Reflective Sensor is turned
on and the See-through Sensor is turned off. However, the reflective sensor may not be able to
detect the label gap on special label materials. For example, when printing on labels with thick
liner, colored liner, or back graphics, then the see-through sensor would need to be enabled
since the reflective sensor may not work correctly.
To turn the See-through Sensor on, please do as follows:
1.
Power off the printer, press and hold the FEED key.
2.
Power on the printer (while still holding the FEED key) and the printer will beep 3 times.
Keep holding the FEED key, wait for the STATUS light turn red and READY light flash
green, then release the FEED key. The printers will automatically print "SEE-THROUGH
SENSOR IS ON". This indicates that the See-Through Sensor is turned on (and the
Reflective Sensor is turned off).
3.
To turn off the See-Through Sensor, please repeat above-mentioned procedures. Then the
printer will print "SEE-THROUGH SENSOR IS OFF" to indicate that the See-Through
Sensor is turned off.
For checking the status of See-through Sensor (on or off), please perform Auto Sensing once. If
both of READY and STATUS lights are green when doing Auto Sensing, then the See-through
Sensor is on. If both of READY and STATUS lights are orange, then the See-through Sensor is
off.
【
】
Note
When the See-through Sensor is enabled, the Label Sensor must be placed in the center of
the printer.
Falcon 4D Plus User's Manual
SEE-THROUGH SENSOR IS ON
or
SEE-THROUGH SENSOR IS OFF
27
Advertisement
Table of Contents
