Cutter Installation - Century Falcon 4D Plus Series User Manual

3-2. Cutter Installation

1 Cutter Module
2 Screw (TAP 3*8) x 2pcs
【 】
Note1
Please power off the printer
before installing the cutter
module.
【 】
Note2
Do not cut self-adhesive
labels! The traces of
adhesive will pollute the rotary
knife and impair safe
operation! The service life of
the cutter is 500,000 cuts with
㎡
160g/ paper weight and
250,000 cuts with 200g/
paper weight.
1. Open the top cover by
pressing the Cover
Open Buttons on both
sides.
2. Loosen and then lift the
upper print mechanism
by pressing the locking
tenons.
3. Unlock the front cover
piece by pushing locks
inward.
4. Lift/take off the front
cover piece according to
the direction shown in
the figure.
5. Plug in the cable
connector of the cutter
module onto the
switchboard socket.
【 】
Note
Before plug the connector into
socket, please check the pin
first.
Falcon 4D Plus User's Manual
【 】
Note3
The max paper cutting width is 116mm
【
Suggestion
㎡
When installing the cutter module, set the stop position to 30
in CLabel and the E value is 30.
20
1
】
2