3. Accessory
3-1. Stripper Installation
1
Stripper Module
2
Screw (TAP 3*8) x 2pcs
【
】
Note1
Please power off
the printer before installing the
stripper module.
【
】
Note2
Label liner
thickness is recommended to
be 0.06mm ± 10% with basic
㎡
weight 65g/
± 6%.
【
】
Note3
The max width for
stripper is 110mm
【
】
Suggestion
When using
the stripper module, set the
stop position to 9 in CLabel
and the E value is 9.
1.
Open the top cover by
pressing the Cover
Open Buttons on both
sides.
2.
Loosen and then lift the
upper print mechanism
by pressing the locking
tenons.
3.
Unlock the front cover
piece by pushing locks
inward.
4.
Lift/take off the front
cover piece according to
the direction shown in
the figure.
Falcon 4D Plus User's Manual
1
17
2