Control Panel; Led Status - Century Falcon 4D Plus Series User Manual

4. Control Panel

4-1. LED Status

Press and hold the FEED key then power on the printer, the printer will beep 3 times and enter
into Self-Test status. If keep holding the FEED key, the status will change in sequence to Auto
Sensing Mode, Dump Mode, Direct Thermal Mode, Thermal Transfer Mode, See-through Sensor
on/off, and then return to Self-Test again. These different statuses can change the setting of
printer, they are described as follows:
FEED
READY Green
STATUS
READY Red (Flash)
STATUS Orange
READY
STATUS Orange
READY
STATUS Orange
READY
STATUS Red
READY
STATUS Red
READY
STATUS Red
READY
STATUS Red (Flash)
Falcon 4D Plus User's Manual
LED Light Beep
Normal
1
status
Press and hold the FEED Key then power on the printer.
3
Self-Test
Orange
Auto Sensing
(Flash)
1
Mode
Green
(Flash)
1 Dump Mode
Red Direct
(Flash) 1
Thermal (DT)
Mode
Orange Thermal
1
(Flash) Transfer (TT)
Mode
Green
See-through
1
(Flash)
Sensor on/off
Return to Self Test
24
Status
Normal status
Printing Self-Test page, for
operation instructions please refer to
page 25.
Printers currently in Auto Sensing
Mode, for operation instructions
please refer to page 26.
Printers currently in Dump Mode, for
operation instructions please refer to
page 26 .
Set the printer to Direct Thermal
(DT) Mode, for operation
instructions please refer to page 26.
Set the printer to Thermal Transfer
(TT) Mode, for operation instructions
please refer to page 26.
Set the See-through Sensor on or
off, for operation instructions please
refer to page 27.
Printer is currently downloading F/W
Description