Advertisement
Convection Microwave
Oven Installation
instructions
IMPORTANT
NOTES TO THE INSTALLER
.
Read all instructions
contained
in these installation
instructions before installing the Convection
Microwave
Oven. This oven can be built into a cabinet
or wail
by itself or above any electric
wail oven or warming
drawer.
Remove aii packing
material
from inside the oven
cavity
before connecting
the electrical
supply to the
Convection
Microwave
Oven. DO NOT REMOVE THE
WAVEGUIDE
COVER, which is located
on the cavity
ceiling.
See Figure 2A.
Waveguide Cover_
Oven Cavity
Door Seals
and Sealing
Surfaces
Hinge
Safety
Door Latch ,_
Figure 2A
Figure 2B
3.
Remove the 2 shipping
duct supports (see Figure 2B) by
removing
the 2 screws securing
each side. Reinsert 2
screws (each side) to secure the stainless cover.
4.
Remove the feature
sticker, if there is one, from the
outside of the door.
.
Check the oven for any damage,
such as misaligned
or
bent door, damaged
door seals and seaiiing
surfaces,
broken or loose door hinges and latches and dent inside
the cavity
or on the door.
If there is any damage,
do not operate
the oven and
contact
your dealer
or KENMORE
AUTHORIZED
SERVICER.
6.
Observe
all governing
codes and local ordinances.
7.
Be sure to leave these instructions
with the consumer.
iMPORTANT SAFETY
iNSTRUCTiONS
Never use your appliance
for warming
or heating
the room.
Prolonged
use of the oven without
adequate
ventilation
can
be dangerous.
CARPENTRY
Refer to Figure 1 for the dimensions
required
for your
appliance,
and the space necessary
to install the oven. The
oven support surface should be solid plywood
or similar
material,
the surface
must be level from side to side and
from front to rear.
ELECTRICAL REQUIREMENTS
The appliance
operates
on a 120 volt, 60 Hz electrical
supply with a separate
ground wire.
Provide a separate
circuit with a fuse or circuit
breaker
rated for 15 amps.
Observe
all governing
codes and local ordinances
To prevent damage
to the oven control,
during
cold
temperature
weather, wait at least three (3) hours
after
receiving
this oven before supplying
power to the
appliance.
This will prevent possible damage
to the built-in
oven control
at power on.
CABINET INSTALLATION
The Convection
Microwave
Oven can tip when the door is
open. The Anti-Tip
brackets
supplied
with the Convection
Microwave
Oven must be attached
to the cabinet
and
the appliance
to prevent tipping
of the unit and injury to
persons.
IMPORTANT
NOTE TO THE CONSUMER
Keep these instructions
with your Owner's
Guide for future
reference.
ANTI-TIP BRACKETS INSTALLATION INSTRUCTIONS
1.
Unpack the Convection
Microwave
Oven and find the
2 Anti-Tip
brackets
and screws included
in the literature
package.
2.
Install the Anti-Tip
bracket
in the cabinet
as shown
on Figure 3. Note: To prevent damage
to cabinet,
it is
recommended
to drill 1,_6"(0.16 cm) diameter
pilot holes
before installing the Anti-Tip
brackets.
E
2
Advertisement
