Tripp Lite ISOBLOK2-0 Owner's Manual

ADDENDUM to Owner's Manual #93-1153
1111 W. 35th Street, Chicago, IL 60609 USA
www.tripplite.com/support
MOUNTING TAB
A mounting tab and screw are enclosed for permanent mounting of your Isobar Direct Plug-In
Surge Suppressor. USE THIS TAB ONLY IF LOCAL REGULATIONS ALLOW
PERMANENT MOUNTING OF YOUR SURGE SUPPRESSOR.
DO NOT USE MOUNTING TAB AND SCREW IN CANADA.
CANADIAN REGULATIONS PROHIBIT PERMANENT
MOUNTING OF THE ISOBAR DIRECT PLUG-IN SURGE
SUPPRESSOR. USE OF THE MOUNTING TAB WILL
VOID ALL WARRANTIES AND INSURANCE OF THE
ISOBAR DIRECT PLUG-IN SURGE SUPPRESSOR.
If your local regulations allow permanent mounting, simply slide tab into slot on the top panel
of the surge suppressor. Adjust tab until it is flush with the rear of the surge suppressor. Secure
tab to surge suppressor with supplied screw. Secure surge suppressor to your receptacle's cover
plate with cover plate screw.
To reduce the risk of electric shock, disconnect power to the receptacle before installing or
removing the Isobar. When removing receptacle's cover plate screw, the cover plate may fall
across plug pins or receptacle may become dislodged.
Copyright © 2011 Tripp Lite. All rights reserved. Isobar
201112054 93-1239.indd 1
Isobar
Surge Suppressors
WARNING
CAUTION
is a registered trademark of Tripp Lite.
®
®
Ultra-Series
Direct Plug-In
12/7/2011 2:56:31 PM
201112054 93-1239