Weslo Sport 350 Treadmill User Manual page 6

3. With the help of a second person, position the treadmill
with the Uprights (14, 15) in the vertical position as
shown. Hold one of the Handrails (4) near the Right
Upright (15).
Route the Wire Harness (53) through the bracket on the
Handrail (4) and out the large hole on the side of the
Handrail. Insert the bracket on the Handrail into the top
of the Right Upright (15). Attach the Handrail with two 1"
Bolts (16), two 1/4" Washers (32), and two 1/4" Star
Washers (7) as shown. Do not tighten the Bolts yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
4. Hold the Console Base (87) and the Console (11) near the
Right Upright (15). Insert the Wire Harness (53) through
the indicated plastic tie on the Console Base and up
through the hole in the Console Base. Remove the tape
from ends of the small wires in the Wire Harness. Set the
Console Base onto the Handrails (4). Attach the Console
Base with four 3/4" Screws (5) (only two Screws are
shown). Start all four Screws before tightening them.
Touch the right Handrail (4) to discharge any static.
Locate the two wires in the Wire Harness (53) that have
L-shaped connectors on the ends. Press the connectors
onto the two tabs on the switch shown in inset drawing 4a.
Connect the other two wires in the Wire Harness (53) to
the back of the Console (11) in the locations shown by
the arrows in drawing 4. The connectors should slide
easily into the sockets and snap into place (see draw-
ings 4b and 4c). If the connectors do not slide easily and
snap into place, turn the connectors and then insert
them. IF THE CONNECTORS ARE NOT INSERTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
5. Set the Console (11) into the Console Base (87). Make
sure that no wires are pinched. Attach the Console to
the Console Base with six 3/4" Screws (5) in the locations
shown. Start all six Screws before tightening them.
Insert any extra Wire Harness (53) into the right Handrail
(4) and right Upright (15). Securely tighten the plastic
tie to prevent the Wire Harness from slipping. Then,
cut off the end of the plastic tie.
3
14
4
87
4
53
5
15
4b
5
87
53
Tie
4
15
6
Large
Hole
53
Bracket
4
7
7
16
32
11
53
Tie
4a
Tabs
4c
11
5
5
5
16
32
15