Assembly - Weslo Sport 350 Treadmill User Manual

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top
of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If
there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive
cleaner.
Assembly requires the included allen wrenches
wire cutters , adjustable wrench
To identify the assembly hardware, see the PART IDENTIFICATION CHART in the center of this manual.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the tread-
mill onto its left side as shown. Partially fold the Frame
(84) so the treadmill is more stable. Do not fully fold the
treadmill until it is completely assembled.
Attach four Base Pads (33) to the Base (38) with four
3/4" Tek Screws (31). Attach a Wheel (42) to the right
side of the Base with a Wheel Bolt (41) and a Wheel Nut
(43). Do not overtighten the Wheel Bolt; the Wheel
should turn freely.
2. See drawing 2a. Make sure that there are two U-nuts
(60) in the bottom of each Upright (14, 15).
Identify the Right Upright (15), which has a large round
hole and a slot near the lower end. While a second per-
son holds the Right Upright near the Wire Harness (53),
insert the end of the Wire Harness into the round hole
and out of the upper end of the Right Upright.
Slide the slot in the Right Upright (15) onto the Upright
Lock Bracket (9) (see drawing 2b); slide the Right Upright
down until it reaches the Base (38). Make sure that the
Wire Harness (53) is not pinched. Attach the Right
Upright to the Base with two 2 1/2" Bolts (10) and two 5/16"
Star Washers (2). Do not tighten the 2 1/2" Bolts yet.
With the help of a second person, tip the treadmill onto
its other side. Attach the Left Upright (14) as described
above. (Note: There is not a wire harness on the left
side.) Attach the other Wheel (not shown) to the Base
(38) as described in step 1.
and your own phillips screwdriver
, and needlenose pliers
1
41
42
84
43
38
2
15
Slot
Round Hole
2a
5
.
33
31
33
33
31
14
53
9
2
38
2b
14, 15
Side
View
60
,
33
31
31
10
9
15