Installation Procedure - Haier AU182AFERA Installation Instructions Manual

Installation Procedure

1. Accessories
"Edging" for protection of electric wires from an
opening edge.
2. Selection of the place of installation
Select the place of installation satisfying the following conditions and, at the
same time, obtain a consent from the client or user.
Place where air circulates.
Place free from heat radiation from other heat sources.
Place where drain water may be discharged.
Place where noise and hot air may not disturb the neighborhood.
Place where there is not heavy snowfall in the winter time.
Place where obstacles do not exist near the air inlet and air outlet .
Place where the air outlet may not be exposed to a strong wind.
Place surrounded at four sides are not suitable for installation. A 1m or more
of overhead space is needed for the unit.
Mount guide-louvers to place where short-circuit is a possibility.
When installing several units, secure sufficient suction space to avoid short
circuiting.
(1) Open space requirement around the unit
Air inlet
L
2
Air
inlet
Air outlet
Case
Distance
open
L
1
L
2
L
3
(2) Installation where the area with strong winds.
Install the unit so that the air outlet section of the unit must NOT be faced
toward wind direction.
L
3
500
(Servicing
space)
L
1
I
II
open
300 300
150 300
Installation of outdoor unit
Note :
(1) Fix the parts with screws
(2) Don't intake the strong wind directly to the
outlet air-flow hole.
(3) A one meter distance should be kept from the
unit top
(4) Don't block the surroundings of the unit with
sundries
Unit: mm
III
500
open
150
13
Edging
NO
Wind direction