Kenwood DNX7380BT Quick Start Quide page 25

Unit
1 To prevent a short circuit, remove
the key from the ignition and
disconnect the
2 Make the proper input and
output wire connections for each
unit.
3 Connect the speaker wires of the
wiring harness.
4 Connect the wiring harness wires
in the following order: ground,
battery, ignition.
5 Connect the wiring harness
connector to the unit.
6 Install the unit in your car.
7 Reconnect the
-
8 Press the <Reset> button.
9 Perform the Initial Setup. See First
Step (P.6).
● Non-Japanese cars
NOTE
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
DNX7380BT/DNX7380BTM/DNX5380BT/DNX5380/DNX5380M
battery.
-
battery.
Bend the tabs of the
mounting sleeve
with a screwdriver
or similar utensil and
attach it in place.
25
● Toyota, Nissan or Mitsubishi car
= (M5x6mm) or
~ (M5x7mm)
Car Bracket
Escutcheon
Attach accessory 6 to the unit.
● General Motors cars
1) Cut out accessory 0 to meet
the shape of the opening of the
center console.
2) Attach accessory 0 to the unit.
Cut out to meet the shape of
the opening in the vehicle.
= (M5x6mm) or
~ (M5x7mm)
6
0