Frequency Response ( 3dB) 78 Hz–20 kHz For five years from the date of purchase, Snell Acoustics will repair for the original owner any defect in materials or workmanship that occurs in normal use of the speaker system, without Recommended Amplifier Power 10–150W...
5) Place the speaker into the rough opening. AMC800 AMC900dp 6) Level the speaker and tighten the screws, being careful not to over tighten them. See diagram below for details. 65 Hz-20 kHz 78 Hz-20 kHz 10–200W 10–150W Turn the mounting clamps against the 4 ohms 6 ohms...
1) A utility knife, an electric jigsaw, or other means of cutting a hole in the mounting surface. 2) A #2 Phillips screwdriver. The Snell AMC loudspeaker enclosure is a thin, but strong, aluminum tub. It is both damped and 3) A wire cutter or stripper for preparing the speaker wires.
Page 5
Note: Custom paint and grilles are available for an extra charge. installations. These placement recommendations apply to all the AMC models, whether you are using AMC900dp (dipole surrounds) or AMC700 or 800 (direct speakers). When selecting installation locations for the AMC 700 and 800, remember that you can increase the diffusion of their sound by aiming their DPT drivers away from the listening area (see the “Aiming the DPT”...
Page 6
In addition to providing an extremely clean wide range response, the DPT have the added and right ear discrimination is at a maximum. This gives the maximum sense of “envelopment” feature of an adjustable waveguide (in 45 degree increments). This unique Snell feature or being surrounded by sound. Rear...
Need help?
Do you have a question about the AMC700 and is the answer not in the manual?
Questions and answers