Connect the appliance to the mains power supply.
A beep may be emitted by some models, to indicate that the temperature alarm has intervened:
press and hold the button to switch off acoustic alarms. As applicable, insert the anti-bacterial/anti-
odour filter into the fan as indicated on the filter package.
Note: after switching on, the refrigerator needs approximately 4/5 hours to reach the correct
temperature for storing a normal fridge load of food.
Clean the appliance regularly using a cloth and a solution of
lukewarm water and neutral detergent specifically formulated for
refrigerator interiors. Never use abrasive detergents. Clean inside
the defrost water drain outlet on the rear wall of the refrigerator
(near the fruit and vegetable crisper drawer) regularly, using the
tool supplied with the appliance so as to ensure defrost water is
removed correctly (see figure).
Before all cleaning or maintenance procedures, unplug the
appliance from the mains or disconnect the electricity supply.
CHANGING THE BULB OR LED
Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions
in accordance with the type of lighting fitted in your appliance.
Only use bulbs of the same type, which can be requested from the After-Sales Service and
Lighting type 1)
1. Loosen the screws and take off the lamp cover.
2. The lamp has a bayonet bulb and needs to be pulled out, not
unscrewed, following the directions of the arrows as indicated.
3. After the new bulb has been inserted, replace the lamp cover
and wait five minutes before plugging the appliance back in.
Lighting type 2)
To remove the light bulb, turn anticlockwise as shown in the
figure. Wait for 5 minutes before reconnecting the appliance.
Lighting type 3)
If the product has LED lighting which is in need
of replacing, contact the After-Sales Service for
LED lights last longer than normal bulbs, they
illuminate better and are more environmentally
(depending on the model)