Wlan Module - HP Omni Pro 110 Maintenance & Service Manual

WLAN Module

Description
WLAN module (802.11b/g/n) (1x1 mini card)
The WLAN module is connected to the system board. The module is secured with two screws and
has one connected antenna.
To remove the WLAN module:
1. Prepare the computer for disassembly (see
on page
2. Position the computer with the rear facing you.
3. Remove the small rear cover (see
4. Remove the stand (see
5. Remove the right rear cover (see
6. Remove the heat sink (see
7. Disconnect the antenna cable from the module, and then remove the screws that secure the
module to the computer.
Figure 7-14
42 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
27).
Stand on page
Heat Sink (Thermal Module) on page
Removing the WLAN module screws and antenna
Preparing to Disassemble the Computer
Small Rear Cover on page
29).
Right Rear Cover on page
Spare part number
634906-001
28).
35).
38).