Advertisement
Product Features
• Extend a 1080p (24Hz), or a 1080i (60Hz), signal up to 150 ft. using
Cat6 cabling, or up to 100 ft. using Cat5 cabling
• Fully automatic equalization up to 40dB—no system control required
• No external power required
• HDCP compatible
Optional Accessories
• N046-000 110 Punchdown Tool
• N048-000 Cable Stripping Tool
• N202-Series Cat6 24Awg, solid wire patch cables
• N222-01K-GY Gray 1,000-ft. Cat6 solid wire bulk cable
• P568-Series High Speed HDMI cables
Installation and Operation
Refer to the installation diagram on page 3 as you perform these steps.
Note:
1. Test to make sure the entire installation works properly before pulling cables
through ceilings/walls.
2. To achieve maximum distance and performance, 24Awg solid wire Cat5e/6
cable must be used. The use of stranded wire Cat5e/6 cable, or cable with a
gauge size higher than 24Awg will result in shorter extension distance. All
Tripp Lite N202-Series Cat6 cables are made with 24Awg, solid wire cabling.
3. Make sure the power to all devices you are connecting to is turned off prior to
installation.
4. The Green LED will illuminate to indicate that power is being received from the
source and monitor. When functioning properly, only the Green LED will be lit.
If the Red LED is illuminated, it means that the remote receiver is not receiving
a functional signal from the source.
201111155-93-2787.indd 2
2
11/17/2011 4:50:33 PM
Advertisement
