Table of Contents
Advertisement
Chapter 2: Getting Started
2.1 Hardware Installation
1.
Plug the USB 3.0 to Gigabit Ethernet Adapter directly into an
available USB 2.0 port (Recommend USB 3.0 port) on your
computer.
2.
Connect one end of your network cable into the RJ45 port of USB
3.0 to Gigabit Ethernet Adapter.
3.
Connect the other end of the network cable into an available
Ethernet port on your router, switch, or any other networking
device.
2.2 Driver Installation
The following section shows you how to install the USB 3.0 to Gigabit
Ethernet Adapter driver on different operating systems.
Important!
Please install the software, before connecting the USB 3.0
to Gigabit Ethernet adapter to your system.
CB-U300GNA
Page 5
Advertisement
Table of Contents
