Vantec CB-ISA225-U3 Installation Manual

Installation Guide
1.
Verify the package contents.
2.5"/3.5"/5.25" SATA Device
To System USB port
4a.
Carefully connect the desired hard drive to the adapter.
WARNING: Please make sure the power connectors are oriented
correctly before connecting. Incorrect connection may cause
severe damage to your hard drive and/or electrical shock.
To System USB port
Once securely connected, you may switch ON the Adapter for device that need to
5.
power using AC Adapter. For 2.5" PATA(IDE) device you can skip this step. After
Powering ON, wait 20 seconds before proceeding to the next step.
Information in this document is subject to change without notice.
Printed in China
Printed on Recycled Paper. Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
2.
Prepare your device and the Adapter.
3.5"/5.25" PATA(IDE) Device
Note:
For ALL IDE device, please set the jumper setting on the drive to Master Single drive mode*.
To System USB port
4b.
Carefully connect the desired hard drive to the adapter.
*For Jumper settings, please refer to your hard drive manufacturer's
documentation.
6.
Proceed to connect the Adapter's USB to a free USB port.
3. Note that there is an On/Off switch located along the AC power
cable. Please make sure it is Off. (For 2.5" IDE, skip to Step 4c)
2.5" PATA(IDE) Device
4c. Carefully connect the desired hard drive to the adapter.
Proceed to step 6.
AutoPlay
Disk(D:)
Open folder to view les
7. When connected properly, the hard drive should be
automatically detected and begin 'AutoPlay.'
www.vantecusa.com
Copyright © 2016 Vantec Thermal Technologies. All Right Reserved. All Registered Trademarks Belong To Their Respective Companies.
To System USB port
Note:
Missing pin on the drive
Interface MUST align with the
plugged hole on the adapter
Interface side.
AutoPlay
Disk(D:)
Open folder to view les
v1.01 Model: CB-ISA225-U3