2.2 Driver Installation ............... 7 2.2.1 Installation for Windows ............8 2.2.2 Installation for Mac OS ............8 2.3 Hardware Verify ............... 10 2.3.1 Verifying for Windows ............10 2.3.2 Verifying for Mac OS X ............11 CB-CU300GNA Page 2...
Chapter 1: Introduction 1.1 Product Introduction Vantec introduces USB-C Adapter with Gigabit Ethernet capability. This adapter uses USB 3.1 Type C interface on the latest generation of the laptop to connect to your Gigabit Network. With Plug and Play, you can easily gain gigabit network speeds of up to 1000Mbps.
Supports crossover detection and auto- correction Supports IPv4/IPv6 packet Checksum Offload Engine (COE) to reduce CPU loading, including IPv4 IP/TCP/UDP/ICMP/IGMP & IPv6 TCP/UDP/ICMPv6 checksum check & generation Supports TCP Large Send Offload V1 CB-CU300GNA Page 4...
Page 5
Support Wake-on-LAN Function Supports suspend mode and remote wakeup via link- change, Magic Packet, Microsoft Wakeup Frame and external wakeup pin Supports Bonjour wake-on-demand Advanced Power Management Features Supports power management offload (ARP & NS) CB-CU300GNA Page 5...
Operating over 0°C to 70°C temperature range 1.3 System Requirements Microsoft Windows 7, 8,10 Mac OS X 10.6 or Greater USB 3.1 Type C Port 1.4 Package Contents USB-C Gigabit Ethernet Adapter Driver CD User Manual CB-CU300GNA Page 6...
2.2 Driver Installation The following section shows you how to install the USB-C Gigabit Ethernet Network Adapter driver on different operating systems. Important! Please connect the USB-C Gigabit Ethernet Network Adapter to your PC before the installing the drivers. CB-CU300GNA Page 7...
Follow the instructions on the screen to install the drivers. 2.2.2 Installation for Mac OS Insert the provided CD into your optical drive. Browse to the Folder CB-U300GNA (share drivers folder with CB-CU300GNA) and select the Mac sub-folder. Start the driver installation by clicking on the installation pkg.
Page 9
*Note: Actual image may vary Follow the instructions on the screen to install the driver. After driver installation is complete, you must restart your computer. Run setup package Review and click continue thru the installation. Use the default setting. CB-CU300GNA Page 9...
Enter Password to continue Click Continue Installation and Click Restart to finish installing the software 2.3 Hardware Verify 2.3.1 Verifying for Windows Click on the “Device Manager” tab in the Windows Control Panel. Start > Control Panel > Device Manager CB-CU300GNA Page 10...
Open the System Profiler by clicking the Apple symbol in the top left corner, selecting About this Mac, then select System Report Expand the “Network” section. With the cable connected, you should see the following devices in the list. CB-CU300GNA Page 11...