Appendix A Manual Programming - SABINE SWM4000 Series Operating Manual

Appendix A
Manual Programming
R7
Allows manual selection of a frequency group. Pressing SET increases the group number by one. When the correct
frequency is displayed press S.O. (SYNC). For best results when operating multiple systems, set all systems to a single
group; then set each system to a unique channel within that group.
R8
Allows manual selection of a frequency channel. Pressing SET increases the channel number by one. When the
correct frequency is displayed press S.O. (SYNC).
R23
Display the current frequency in MHz. Press again to display group and channel.
R9
Hold down the SET key and press MENU to lock or unlock the receiver. Locking prevent the current receiver settings
from changing.
R5
Indicates RF activity. Only one antenna is active at any one time.
R21
Indicates a low transmitter battery charge.
R26
The INCOMPATIBLE warning indicates that the receiver and transmitter are set to incompatible frequency bands.
Contact your retailer for assistance.
Any option displayed on screen will generally time out after five seconds
SW40-RF Module Front
Volume (Gain)
R2
Squelch
R3
RF signal
R4
Active antenna
R5
I.R. sensor
R6
Group selection
R7
SW40-RH LCD display
Antenna status
R5
Group selection
R7
Manual channel selection
R8
Lock/unlock receiver settings
R9
Transmitter Battery status
R21
Automatic frequency selection
R22
Display frequency
R23
Incompatable frequency
R24
*
Available only on the SW40-RH
Sabine SWM4000 Smart Spectrum
*
Channel number
R8
Lock all controls
R9
Set
R10
Menu
R11
Sync
R12
Audio signal
R13
Wireless
®
R2 R5 R6
VOL TRUE DIVERSITY
A
ANT
I.R.
B
S.Q.
RF
R3 R4
R5
R7
R21 R22
10
R9
R10 R12
SET
UHF
RECEIVER
GROUP CHANNEL
02 04
SYNC
MENU
SW40-RM
AF
R7 R8
R11 R13
R24
INCOMPATIBLE
R8
R23
R9