Control Panel Lights - Oki Microline 8480 FB User Manual

With the Printer Powered Up and Off Line
Switches
+

Control Panel Lights

Light
POWER
AUTO GAP
ALARM
Task Performed
Press and hold both the LOAD and the SHIFT
switches to change the printhead gap setting. The
factory default is Auto Gap in which the required
printhead gap is sensed automatically by the
printer. Use these switches to change the setting to
a manual head gap setting if you are not getting
good print results with AutoGap. See "Gap Control"
on page 46 for more information.
On
Printer is turned
on.
Auto Gap mode is
selected (the
default).
• Paper is out.
• A paper jam has
occurred.
See
"Troubleshooting"
on page 69 for
more information
Microline 8480FB User's Guide
Control Panel • 12
Off
Printer is turned
off.
A Manual Gap
setting is engaged.
Printer operation is
normal.
a
Blinking
N.A.
Manual Gap setting
alarm.
• Awaiting removal of
single sheet/form.
• Media switch is
taking place.
• If both the ALARM
and SEL lights are
blinking, the cover
is open.
• If both the ALARM
and AUTO ALIGN
lights are blinking,
there is an
unrecoverable
error. Try turning
the printer off, then
on again. IF this
doesn't clear the
problem call your
service dealer