Operation - Pelonis NF15-9BMB Owner's Manual

OPERATION

Place the heater on a firm, level surface free from obstructions, and at least 3 ft.
(0.9m) away from any wall or combustible material.
With the Power Switch in the OFF position, plug the heater into a grounded
120V outlet. Always operate the heater in the upright position.
To use the fan only function and no heat needed, please push the Power and Setting
Control switch（B）to FAN(
Indicator Light (A) will illustrate.
To turn the heater on, please turn the Power and Setting Control switch (B)
clockwise to the desired position LOW(
Thermostat Control (C) to your desired setting from MIN to MAX .
For quicker heat up, you can turn the Power and Setting Control switch (B) to
position HIGH(
the room reaches a comfortable temperature, slowly turn (C) counter-clockwise
until the Power Indicator Light (A) turns off. This is the point at which the
thermostat setting equals the room temperature and the thermostat will auto
matically turn the heater on to and off to maintain this selected temperature. Then
you can turn (B) to position LOW(
To turn on the Oscillation feature (D), turn the Oscillation switch "ON".
Note: If the fan was shut off, either because of by pressing POWER to select OFF,
or the unit was turn off automatically for high room temperature, the oscillation
will be off.
RESET INSTRUCTIONS
This heater is equipped with an internal High Limit Switch which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
IF THE UNIT SHUTS DOWN
1) TURN THE UNIT OFF
2) UNPLUG UNIT AND WAIT 10 MINUTES
3) PLUG IN AND TURN ON
Symbol
FAN
), and turn the Thermostat Control (C) to MAX , when
) position, the fan inside will work and Power
) or HIGH(
The heater turns off
F
The heater operates at 900 watts
The heater operates at 1500 watts
) for energy savin
4
) , and turn
Function
an working only
g and prevent overheat.