Operation - Pelonis HO-0221 Owner's Manual

OPERATION

1. Check that neither the appliance nor the power cable has been damaged in any
way during transportation when first using.
2. Place the heater on a firm, level surface free from obstructions, and at least 3 ft.
(0.9m) away from any wall or combustible material.
3. With the Power Switch knob in the OFF position, plug the heater into a grounded
120V outlet. Always operate the heater in the upright position.
4. To turn the heater on, while turning the Power Switch knob clockwise to the
desired position (LOW/MED/HIGH) and turning thermostat to your desired
setting from MIN to MAX.
5. When the room reaches a comfortable temperature, slowly turn the Thermostat
Control counter-clockwise until you hear one click sounds. This is the point at
which the thermostat setting equals the room temperature. At this setting, the
thermostat will automatically turn the heater on and off to maintain this selected
temperature.
6. Turn the Power Switch knob to OFF and unplug the heater when you finish
usin g it.
Note: This heater include a safety tip over switch, which will shut the heater off in case
it is tipped over. If at any time, the heater does tip over, please put the heater back in
the upright position (wheels on bottom, controls on top). The heater will resume its
normal operation.
RESET INSTRUCTIONS
This heater is equipped with an internal High Limit Switch which causes the unit to
stop operating in the event the internal temperature exceeds normal operating
temperatures.
IF THE UNIT SHUTS DOWN
1) TURN THE UNIT OFF
2) UNPLUG UNIT WAIT 10 MINUTES
3) PLUG IN AND TURN ON
IF YOUR HEATER FAILS TO OPERATE:
Be sure it is plugged in and that the electrical outlet is working.
Check for any obstruction. If you find an obstruction turn the heater OFF. Unplug
the heater and wait at least ten minutes for it to cool. Carefully remove the
obstruction. Plug the heater back in and restart it as described under OPERATION.
If you still notice the same defect above mentioned, remove the plug from the
socket and have the appliance serviced by authorized service personnel only.
Check that the thermostat is not set too low. With the power switch set to a heat
5