Telex Via Data Terminal; Data Call - Sailor System 5000 MF/HF User Manual

6.3

Telex via data terminal

6.3.1 Radio Telex software
Basically the system consists of the Radiotelex software and a Radiotelex module (modem).
The Radiotelex software runs on a computer of one of the following types:
• a marine PC,
• a communication computer, or
• an ordinary PC not using Windows. (Running DOS)
Data terminal TT-3606E offers advanced but simple to use radio telex communication.
The TT-3606E Telex terminal offers the following features:
• Composing and transmitting online messaging
• Transmitting pre-composed messages
• Scanning for incoming telex calls (scan specific channels on specific hours)
• Logging incoming Telex messages
Complete operators manual are included in the Radio telex Software package.

7 Data call

Data service via MF/HF is offered by various service providers utilizing their individual
application hardware and software external to the MF/HF equipment.
To operate data service the MF/HF radio must have been prior configured to allow operator
selection of Remote mode of operation.
This paragraph refers only to the operational part on the radio side. For details on the
operation of the data service application equipment refer to the suppliers documentation.
To prepare the MF/HF for a data call select Remote mode of operation by toggling the Mode
button until "Remote" is indicated in the display. Data calls may now be setup from the
external data equipment.
Having finalized the data call(s) revert to preferred mode of operation by toggling the Mode
button until required mode of operation is indicated in the display.
Note: Shall be enabled in the setup menu before use !!!
0735 39