Cleaning Instructions - Wells UT Series Operation Manual

Ut/uty/uts/uth series self-leveling drop-in dispensers for round dinnerware

Hide thumbs Also See for UT Series:

Service manual (9 pages)

Table Of Contents

Table of Contents

PREPARATION

Unplug heated units and allow to cool before cleaning.

Unload all dinnerware from the dispenser before cleaning.

Use care to avoid removal or deformation of carriage springs.

FREQUENCY

Daily

TOOLS

Cleaner/polish formulated for stainless steel.

Mild detergent, soft clean cloth or sponge, plastic scouring pad.

Vacuum cleaner with long wand.

CLEANING

1. Unplug heated dispensers and allow to cool. Unload all dinnerware

from the dispenser.

2. Remove the open tube assembly from the counter by lifting straight

up. Use care to avoid removal or deformation of carriage springs.

3. Wipe entire open tube assembly with a soft clean cloth or sponge

moistened with water and mild detergent. Stubborn food particles

may be cleaned off with a non-abrasive plastic scouring pad.

4. Rinse by wiping with a clean cloth or sponge moistened with clean

water. Allow to air dry.

5. Restore the luster and protect the stainless steel by wiping with a

cleaner/polish formulated for stainless steel.

6. Clean interior of shield or cabinet by vacuuming loose food and

other debris. Use of a vacuum with a long wand will make this step

easier.

7. Reinstall open tube assembly into counter.

Use care to prevent pinched fingers.

Use care to avoid removal or deformation of carriage springs.

Be sure tube assembly is dry before installing.

8. Plug heated dispensers back into electrical power.

Procedure is complete