Precautions And General Information; Agency Approval Information - Wells UT Series Operation Manual

This dispenser is intended for use in commercial establishments
only.
This dispenser is intended to dispense dinnerware in establishments
serving food for human consumption. No other use is recommended
or authorized by the manufacturer or its agents.
Operators of this dispenser must be familiar with the dispenser use,
limitations and associated restrictions. Operating instructions must be
read and understood by all persons using or installing this dispenser.
Cleanliness of this dispenser is essential to good sanitation. Read and
follow all included cleaning instructions and schedules to ensure the
safety of the food product.
Disconnect heated dispensers from electrical power before performing
any maintenance or servicing.
DO NOT submerge heated dispensers in water. Do not splash or pour
water on, in or over any controls, control panel or wiring.
The technical content of this manual, including any wiring diagrams,
schematics, parts breakdown illustrations and/or adjustment
procedures, is intended for use by qualified technical personnel.
Any procedure which requires the use of tools must be performed by a
qualified technician.
This manual is considered to be a permanent part of the dispenser.
This manual and all supplied instructions, diagrams, schematics, parts
breakdown illustrations, notices and labels must remain with the
dispenser if it is sold or moved to another location.
This dispenser is made in the USA. Unless otherwise noted, this
dispenser has American sizes on all hardware.
This dispenser conforms to NSF Standard 4 for sanitation only if
installed in accordance with the supplied Installation Instructions,
and operated and maintained in accordance with the instructions
in this manual.
UTH and UTY heated dispensers are

PRECAUTIONS AND GENERAL INFORMATION

AGENCY APPROVAL INFORMATION

U
Listed.
3
WARNING:
Electric
Shock hazard
All servicing requiring
access to non-insulated
electrical components
must be performed by a
factory authorized
technician.
DO NOT open any access
panel which requires the
use of tools. Failure to
follow this warning can
result in severe electrical
shock.
CAUTION:
Risk of
Damage
DO NOT connect or
energize heated
dispensers until all
installation instructions
are read and followed.
Damage to the appliance
will result if these
instructions are not
followed.
STD 4