Advertisement
NOTE
A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all
cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse
blows on a regular basis when the heater is operating. Additional appliances on the same
circuit may exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure
that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire,
electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
STOVE INSTALLATION
1. Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating
instruction section).
2. Plug the unit into a 15Amp/120volt outlet. If the cord does not reach, you may use an
extension cord rated for a minimum of 1875 watts.
OPERATION
To access the controls, go to the back of the stove.
A. MAIN POWER ON/OFF SWITCH
The main power on/off switch supplies power to all stove
functions (heater & flame). The main power indicator light will
illuminate, confirming the unit is turned on.
B. LIGHT DIMMER CONTROL
Controls the light intensity of the log bed display area. Rotate
the knob to choose the desired setting.
C. HEATER ON/OFF SWITCH
The heater on off switch supplies power to the heater
D. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn
the thermostat control clockwise all the way to turn on the
heater. When the room reaches the desired temperature, turn
the thermostat knob counter clockwise until you hear a click.
Leave in this position to maintain the room temperature at this
setting. For additional heat, turn clockwise until you hear the click again and the heater will
turn on.
2
Advertisement
