Page 1
CS4416 CS2307 CS3311 Pictured DATE ~~~~ Feb 12, 07 11563 Aug 10, 09 Dimplex North America Limited 11993 April 12, 10 1367 Industrial Road Cambridge ON Canada N1R 7G8 1-888-346-7539 www.dimplex.com Sept 4, 12 In keeping with our policy of continuous product development, we reserve the right to make changes without notice.
Operation unplug the unit and call Dimplex North America Limited at 1-888-346-7539 for technical support. Electric Stove Manual Control The manual controls for the stove are located in the upper Remote Operation left hand corner on the rear of the stove (Figure 1).
Light Bulb Replacement Partially Reflective Glass Replacement Allow at least five (5) minutes for light bulbs to cool before If the stove was operating prior to servicing allow at least touching bulbs to avoid accidental burning of skin. 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin.
2. Remove the 11 Philips screws that attach the top panel 1. Open stove door. to the stove as shown in Figure 4. There are: four (4) 2. Remove the 11 Philips screws that attach the top panel to screws along each side; and three (3) screws at the front, the stove as shown in Figure 4 (page 6).
8. Remove four (4) Philips screws as shown in Figure 7 to 17. Connect the three (3) wires from the new motor to the release the bottom pan. Terminal Block as they originally were (refer to Figure 8). CAUTION: Use caution when removing the bottom pan 18.
wire clips disconnected in step 6. Figure 12 Long yellow to Heater Cutout ON/OFF Switch 10. Follow steps 1 through 4 in revers order to reassemble the stove. Heater Assembly/Cutout Replacement Short yellow looped to If the stove was operating prior to servicing allow at least element terminals 10 minutes for light bulbs and heating element to cool off to avoid accidental burning of skin.
that hold the Heater Assembly in place from the bottom Figure 15 surface of the pan (Figure 13). 8. Remove the two (2) black metal stand off brackets from Blue wire clip leading to the Heater Assembly by removing the two (2) Philips lower section of stove screws that hold each bracket in place.
Page 11
left terminal of the Remote Control Receiver, the smooth Figure 16 edged cord connects to the center terminal of the 3 Position Switch (Figure 18). 8. Disconnect both wire clips described above and pull old Power Cord through stove and out back of stove. 9.
Troubleshooting Guide PROBLEM CAUSE SOLUTION General Circuit breaker trips or fuse Short in unit wiring. Trace wiring in unit. blows when unit is turned on Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit.
Page 13
PROBLEM CAUSE SOLUTION Heater Heater is not turning off Improper operation Refer to Operation Section Defective Heater On/Off Switch Replace Heater On/Off Switch Defective Thermostat Replace Thermostat Heater is not turning on, but Improper operation Refer to Operation Section flame effect is still functioning Loose wiring Trace wiring in unit Defective Heater On/Off Switch...
Need help?
Do you have a question about the CS2307 and is the answer not in the manual?
Questions and answers