Install Whiteboard Pen; How To Use; Replace Pen Tip; Replace Battery - Qomo Interactive Whiteboard Owner's Manual

Install whiteboard pen

Pen tip
(Left button)

How to use

The Whiteboard pen can simulate three kinds of mouse modes as follows:
1. Mouse move: Put the pen tip close to the whiteboard and move.
2. Mouse left click: Press down the pen tip on the whiteboard and move.
3. Mouse right click: Put the pen tip close to the whiteboard and press down the button on
the pen.

Replace pen tip

When the pen tip gets damaged and can not write properly, please change it with new pen
tip provided with whiteboard. Take off the pen tip cover with clamp, and then replace with
new pen tip.
Notes：
1. When you write on the Whiteboard, please put the pen tip straight on the Whiteboard
writing surface, or it will cause bad writing effect.
2. Please change the battery termly to make sure the normal use of the Whiteboard pen.
3. Please charge the pen only by pen charger provided with whiteboard.
4. When the Whiteboard pen is not used for a long time, it will change to stand-by mode
automatically. Under this mode, it will no respond when put the pen close to the
Whiteboard. Press the right button or the pen tip to enable the pen to work.

Replace battery

If your electromagnetic pen is using AAA battery and can not be charged, please replace battery
termly. Here is how to install battery:
Open the battery cover on pen, put in an AAA alkalescent battery according to the anode
and cathode (the spring side is the cathode) to the battery hole, and then fasten the
battery cover before use the pen.
Right button
Moving button
—15—
Charger Socket