Installation; Led - Sapido MB-1112 User Manual

8. Q & A
8.1

Installation

1. Q: Where is the xDSL Router installed on the network?
A: In a typical environment, the Router is installed between the xDSL line and the LAN.
Plug the xDSL Router into the xDSL line on the wall and Ethernet port on the Hub
(switch or computer).
2. Q: Why does the throughput seem slow?
A: To achieve maximum throughput, verify that your cable doesn't exceed 100 meter. If
you have to do so, we advise you to purchase a bridge to place it in the middle of the
route in order to keep the quality of transmitting signal. Out of this condition you
would better test something else.
Verify network traffic does not exceed 37% of bandwidth.
Check to see that the network does not exceed 10 broadcast messages per
second.
Verify network topology and configuration.
8.2

LED

1. Why doesn't 3.5G Mobile Router power up?
A: Check if the output voltage is suitable, or check if the power supply is out of order.
2. The Internet browser still cannot find or connect to 3.5G Mobile Router after
verifying the IP address and LAN cable, the changes cannot be made, or
password is lost.
A: In case 3.5G Mobile Router is inaccessible; you can try to restore its factory default
settings. Please press the "Reset" button and keep it pressed for over 7 seconds and
the light of STATUS will vanish. The LEDs will flash again when reset is successful.
3. Why does 3.5G Mobile Router shut down unexpectedly?
A: Re-plug your power adapter. Then, check the STATUS indicator; if it is off, the
internal flash memory is damaged. For more help, please contact with your provider.
http://www.sapido.com.tw/
76
User Manual 1.0