Troubleshooting - Omega Research & Development K9-FIVEc Owner's Manual

L e a r n i n g T r a n s m i t t e r C o d e s
Transmitter Code Learning: This security system will respond to up to 4 different transmitters. This
security system already has two transmitters programmed into the system memory.
When adding or deleting transmitter codes to operate your security system, follow this process:
1) Turn "on" the ignition.
2) Within 5 seconds of turning "on" the ignition, press the valet button switch 5 times.
Note: Siren will chirp, confirming that for the next 10 seconds it's ready to learn a transmitter code.
Note: If a code is not received within 10 seconds, the learning process will automatically terminate.
Note: When the first transmitter code is learned it will erase all other prior codes and thus protect
your alarm against unknown codes being entered without your knowledge.
3) To learn the first transmitter button codes:
Step A. Within 10 seconds of step #2, press the transmitter button you want to arm/disarm/panic
the alarm until you hear one siren chirp to confirm that the code was learned and that the
alarm is ready to learn the disarm regardless of status code.
Step B. Within 10 seconds of step A, press the transmitter button you want for disarm regardless
of status code until you hear two siren chirps that confirm that the code was learned and
that the alarm is ready to learn the remote valet and pre-warn bypass code.
Step C. Within 10 seconds of step B, press the transmitter button you want for remote valet and
pre-warn bypass until you hear three siren chirps that confirm that the code was learned
and that the alarm is ready to learn the 2nd, 3rd or 4th transmitter codes starting at step A.
4) To program the second, third or fourth transmitter codes, repeat steps A, B, & C.
Note: If the valet button is pushed once before step B or C, the alarm will advance to learn the next
transmitter codes starting at step A. Thus, no code is learned in step B and/or C from the transmitter.
This feature is useful for multiple car operation.
5) Turning off the ignition, or 10 seconds of no activity, will automatically turn off this transmitter
learning code program, which is confirmed by one long sounding chirp.
Page
-30
Trouble Shooting
SYMPTOM PROBABLE CAUSE
Alarm arms with
ignition key "on"
Alarm doesn't arm Yellow wire is not
connected correctly
Valet Override
Non-operational
Last door arming
not working
Last door arming The blue, violet or green wire
not working is not connected to the door pin
switches correctly.
Alarm still won't Dip switch #2 was
last door arm not turned "on" in the
Alarm doesn't trigger A blue, violet or green
"on" from doors or hood, wire is still in a triggered
trunk, or accessory
detection devices.
Alarm won't re-arm
SOLUTION
Yellow wire must be
connected so when:
A) With ignition key "on"
there should be 12 volts
to the alarm yellow wire.
B) With ignition key "off"
There should "not" be 12
volts to the alarm yellow wire
Connect the correct wire
to the door pin switches
Must have dip switch #2
in the "on" position from
receiver brain the 4 pin dip switch bank
Disconnect all trigger
wires and re-test one
condition
Valet is "on" Press the Easy Valet
-23
Page
wire at a time
TM
button switch