Orange Wire Connection - Starter Interrupt - Omega Research & Development K9-FIVEc Owner's Manual

ORANGE WIRE CONNECTION starter interrupt
ORANGE WIRE: (500ma Negative Output For Optional Starter Interrupt Relay).
FUNCTION ONE: To provide a constant 500ma ground output for a relay coil only when
alarm hijack is activated, alarm is armed or triggered "on". This allows relay to disable
the starter only when starting vehicle for minimum current draw on battery.
CONNECTION: For Starter Disable: Connect orange wire to the negative side of optional
relay coil pin #86. The wire from ignition key to starter solenoid will read 12 volts only
when ignition key is in start position (cranking the vehicle). Cut this wire at a suitable
location. Ignition key side of this cut wire, connect to pin #85 and #30 of relay. Starter
solenoid side of this cut wire connect to pin #87a of relay.
Note: Only while cranking vehicle will a small drain be on battery from the use of this relay.
Note: If this wire touches 12 volts positive directly or has more than a 500ma ground load,
it will damage this circuit.
DIAGRAM FOR STARTER DIS-ABLE
Alarm AU-Socket
Orange Wire Orange Wire
ALARM
C
BRAIN
O
I
L
Diagram Shows Optional
AU-Socket Color Code &
AU-Socket Red Wire
AU-Pot Wiring.
AU-Socket
SOLENOID
White Wire
86
Starter Motor
87
87A
Relay
Cut Starter Wire
30
85
Page -12
ORANGE WIRE CONNECTION starter interrupt
ORANGE WIRE CON'T:
FUNCTION TWO: To have a relay supply 12 volts positive or ground to other detection
devices when alarm is armed.
Note: Relay in function two will have current draw on battery only while alarm is armed.
SUPPLY GROUND TO
OTHER DEVICES
Connect To Other Device
ff
Alarm
Orange Wire
ALARM
BRAIN
+
To 12 Volts Positive
Ignition Key
Connect To Ground
SUPPLY POSITIVE TO
OTHER DEVICES
Connect To 12 Volts Positive
+
Orange Wire
ALARM
86
87
87A
BRAIN
C
O Relay
I
L
+
30
85
To 12 Volts Positive
Connect To Other Device
Page -13
Alarm
86
87
87A
C
O Relay
I
L
30
85