Arming The System Single Area System - Regency 4734 Owner's Manual

Technical Manuals Online! - http://www.tech-man.com

Arming the System Single Area System

See Section 3.8 for multi-area system information.
Make sure the touchpad's green READY light is lit and
the ARMED light is off.
Enter your access code at any touchpad. When you
finish, the green READY light will go off and the
ARMED light will go on.
You now have a specified amount of time to exit without
causing an alarm. (You and your installer will
determine the exact number of seconds 20-40 seconds
is typical.) If your system is programmed to beep during
the exit delay period, the touchpad will begin beeping to
indicate the countdown of seconds until all zones are
armed.
Not Ready Zones
If you have a "not ready" zone in your system, indicated
when the touchpad's READY light is off and "NOT
READY" displays on your LCD, you will not be able to
arm your system until the zone is ready. Not ready
conditions are caused by such things as a door being left
ajar or a window being left open. Once you close the
door or window or fix whatever is causing the not ready
condition, the system will automatically display
"READY."
To find out which zone is not ready, press
zone number will display on the first line of the
touchpad. The location of the problem will display on
the second line.
The following is an example of a display.
#3 NOT READY:
LOADING DOCK
In a multi-area system, the location on the second line of
the display will be followed by the area name
appropriate for that zone.
STAT
19
. The