Access Codes - Regency 4734 Owner's Manual

Technical Manuals Online! - http://www.tech-man.com
Code 2 feature
Press followed by your access code to turn the
CODE 2
code 2 feature on when arming the system. This will
allow secondary code users, (that is, users whose
profiles have been enabled for the code 2 feature), to
disarm your system one time. (In a multi-area system,
enter your access code before pressing
X-10 Module Activation
If your system includes a Model 4181 Power Line
Interface, you can use X-10 compatible modules to
control devices, (such as lights), in up to 32 locations on
your premises. These devices can be programmed by
your installer to activate automatically or from a
touchpad.
Your installer assigns a code to each module. Each
module also has a pair of digits associated with it.
These digits should be written down in the data section
at the back of this manual (pages 51 to 52).
1. Enter the digits of the device you want to activate
(from chart on pages 51 to 52).
2. Press
DOOR
3. Press to turn the module on or
1

Access Codes

Below is some important information about access
codes. Instructions for changing codes follow.
Access codes must be 4 to 6 digits long.
When selecting access codes, make them as
different from each other as possible to prevent one
user from accidentally discovering another user's
code. Don't choose numbers such as "1111,"
"2222," and so on. While they are easy codes for
you to remember, they might also be easy codes to
break.
.
26
.)
CODE 2
to turn it off.
0