Table of Contents
Advertisement
4.
using warm soapy water, wash out the filter
housing and allow it to air dry.
5.
Make sure you are wearing your respirator
and safety goggles.
6.
Support the hEpa filter element and vacuum
the input side of the filter with a soft brush-
type tip while tapping the filter element.
7.
hold a shop air gun or spray nozzle no closer
than two to three feet from the filter element,
and in a slow and sweeping motion, blow
the remaining contaminants back out the
direction they came (against the direction of
the arrow you previously marked). Be careful
however, if you get too close the jet of air
pressure may blow a hole in the filter.
g0648 Welding Fume Extractor
8.
after cleaning, return the filter to the marked
position in the filter housing.
9.
reassemble and start the machine.
-33-
Advertisement
Table of Contents
