Grizzly G0648 Owner's Manual page 30

8. unwind approximately 15" of filter paper and
fold approximately 6" over one of the con-
veyor ribs so when you push the manual feed
button (Figure 29), the conveyor will draw
the paper through the machine and into the
recovery cabinet.
Note: For assistance, you can use a couple
of pieces of tape to hold the filter paper on the
conveyor.
Figure 29. Supply cabinet manual feed button.
9. remove the five phillips head screws and
the recovery cabinet shroud (Figure 30).
Shroud
Figure 30. recovery cabinet shroud.
10. Connect the machine to power, and push and
hold the manual feed button while watching
the progress of the filter paper as it passes
through the machine.
11. When the filter paper just begins to enter at
the top of the recovery cabinet, release the
manual feed button and walk over to the
recovery cabinet.
-28-
12. remove the end of the filter paper from the
conveyor, and then carefully pull the filter
paper so approximately 15" of paper extends
from the machine.
13. place the end of the filter paper in the slot cut
into the axle, and with your fingers, turn the
axle toward you so you get a couple of wraps
of paper on the roll (Figure 31).
Figure 31. Wrapping the recovery axle.
Make sure that the roll is wrapped in the
directio where, when installed, the filter paper
blocks the view of the roll, as seen through
the window shown in Figure 26.
14. position the recovery axle onto the spring-
loaded spindle cone so that the slot in the
axle engages with the drive tang on the
spindle cone (Figure 32).
tang
Figure 32. Slot and drive tang alignment.
15. push the recovery cabinet manual feed but-
ton to draw up any slack in the filter paper
between the two rolls.
16. reinstall the recovery cabinet shroud.
g0648 Welding Fume Extractor
Slot