Grizzly G0648 Owner's Manual page 32

8.
unplug the vibration motor, lift the vibrating
filter upward and pull the bottom outward
(Figure 36). place the unit on the floor.
Figure 36. dual pleated filter removal.
9. open the dust drawer and clean it out (Figure
37).
Figure 37. dust drawer.
-30-
10. using warm soapy water, wash out the filter
11. inspect for any seal or gasket damage and
Vibration
12. Make sure you are wearing your respirator
Motor
13. Support the filter element and vacuum the
14. When you have removed most of the caked
15. hold a shop air gun or spray nozzle no closer
direction of
air Blowgun
pressure
16. place the vibrating filter into the cabinet.
17. reinstall the spring retaining bolt so
cabinet and dust drawer, and allow them to
air-dry.
replace as required.
and safety goggles.
input side of the filter with a soft brush-type
tip while tapping the outside of the filter with
your other hand.
contaminants, support the filter housing so it
will not fall over during the next step.
than two to three feet from the filter element,
and in a slow and sweeping motion, blow
the remaining contaminants back out the
direction they came (Figure 38). Be careful,
however, if you get too close, the air pressure
may blow a hole in the filter.
Figure 38. Vibrating filter element.
approximately 1" protrudes into the filter
cabinet.
g0648 Welding Fume Extractor