Table of Contents
Advertisement
(1) Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter ID and Password.
(2) Mail
Fill the mailing information. Click Test Account button can exam the mail is workable or not.
From: Enter the sender e-mail address.
To and CC: Enter the recipient email address and separate it with comma or a semicolon (;).
Subject: Enter the message title.
Message: Type the message.
Notice Interval: Set a time gap for mail re-sending when mail has failed to send.
(3) Snapshot
When send out the email, the DVR system will snapshot image of the selected camera channel.
Select Camera: Select the channel that will be snapshot when alarm email is sending out.
Video Size: Select the size of video that will be taken when snapshot. Auto means default size
that chosen by DVR system.
-
Start Recording
Record the video from the selected camera.
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting.
4. In the Start Record prior text box, mark and set the
number in second for the program to begin recording
before the alarm has been trigger. The time range is
1~10 seconds.
5. In the Stop Record after text box, mark and set the
number in second for the program to continue recording after the alarm has ended. The time range is
1~999 seconds. If user doesn't mark and set the time, the alarm recording will continue recording until
alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting. Beside
the PTZ preset point check box, click Detail. In the Trigger PTZ
Preset Setting dialog box, select the PTZ camera number then
select the Enable check box. Select the position of the PTZ
camera when the alarm is activated and ended. For the PTZ
camera end point, user can also select on preset position or Auto
Pan between preset position groups.
61
CHAPTER 3
Advertisement
Table of Contents
