Jacuzzi THE SANTINA Owner's Manual page 20

TROUBLESHOOTING GUIDE
PROBLEM
6. Low water flow from jets.
(Continued)
7. No water flow from jets.
8. Noisy pump and motor.
9. Water leakage at pump
shaft (rotating connection
between pump and motor)
10. Motor will not start
* Note: The skills and tools necessary for the safe repair of this spa require the services of qualified service personnel.
Contact your Jacuzzi Whirlpool Bath Authorized Service Agent or Dealer.
18
PROBABLE CAUSE
F. Suction or discharge line
partially plugged.
G. Pump running at subnormal
speed.
H. Worn or damaged pump seal.
I. Subnormal voltage.
A. Power turned off.
B. Selector switch in OFF.
C. Motor(s) not connected.
D. House circuit breaker
tripped; no power to system.
E. Spa circuit protector tripped.
F. High temperature safety
switch tripped.
G. GFCI tripped.
H. Faulty pump or motor.
A. Clogged strainer(s).
B. Leakage of air into suction
line.
C. Vibrating parts attached to
motor or support brackets.
D. Low water level.
E. Damaged or worn motor
bearings.
F. Impeller rubbing inside case.
G. Debris inside pump.
A. Worn or damaged pump seal.
A. Power off.
B. OFF mode selected.
C. House circuit breaker
tripped or in OFF position.
D. Spa circuit protectors tripped.
E. GFCI tripped.
F. High temperature safety
switch tripped.
REMEDY
F. *
G. *
H. *
I. Call an electrician or your
power company.
A. Turn on power at service panel.
B. Select another function.
C. Check motor plug connections
on System Control Module.
D. Reset circuit breaker.
E. Reset circuit protector.
F. Reset button on heater after
water has cooled; See *Note if
switch continues to trip.
G. Reset GFCI.
H. *
A. Clean strainer(s).
B. Locate and repair leaks.
C. Tighten fasteners.
D. Add water to normal level.
E. *
F. *
G. *
A. *
A. Turn on power at service panel.
B. Select FILTER, HTR/FILTER, or
JETS mode.
C. Reset circuit breaker.
D. Reset circuit protectors.
E. Reset GFCI.
F. Reset button on heater after
water has cooled; see *Note
if switch continues to trip.