Table of Contents
Advertisement
WARNING! Risk of electrical shock or electrocution
Always disconnect power to the pool and/or spa light at the circuit breaker panel
before attempting to service the light. Failure to do so could result in serious injury
or death due to electrical shock. Installation must be performed in accordance with
all applicable federal, state & local installation codes and ordinances by a licensed or
certified electrician or a qualified pool professional. Improper installation may result
in death or serious injury to pool and/or spa users, installers or others due to electrical
shock. In addition, improper installation may cause property damage. This device is
not intended for use in anything other than in-ground pools/spas.
WARNING! Important Safety Information for Light Installation
Do not, under any circumstances, splice wire underwater or behind the light niche
during the installation of this light.
INSTALLER NOTICE: This light's external cord cannot be replaced and should be
handled with care. Any damage to this external cord necessitates replacing the light.
RATED FIXTURE LIFE: The illumination generated by Color Splash LED light fixtures
are based on Light Emitting Diode (LED) technology. The average expected fixture
life is rated 50,000 elapsed time hours under normal operating conditions. Pool Water
Temp: 33 ° F to 97 ° F (1 ° C to 36 ° C), humidity: 0-95% non-condensing.
COLOR SPLASH LED POOL AND SPA LIGHT FIXTURES
Color Splash LED Pool and Spa light fixtures are operated through the light's switch.
No special controller or interface is required. Use a junction box to connect and
operate multiple lights with a single switch.
COLOR SPLASH LED POOL AND SPA LIGHT FIXTURES INSTALLATION
The following steps detail installation of the Color Splash LED light fixture into a new
pool and/or spa construction. Read this section in its entirety prior to beginning any
installation.
INSTALLER NOTICE: A licensed electrician must complete the following steps prior to
installation of this light in a new pool or spa construction.
OPERATION FOR 120VAC AND 12VAC
(NEW POOL AND/OR SPA CONSTRUCTION)
pg 2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Color Splash and is the answer not in the manual?
Questions and answers
Pool light and spa light don’t match. Now spa light out. Pool light working perfectly.
The J&J Electronics Color Splash pool and spa lights may not match if they are not on the same electrical circuit. The lights are “synchronous,” meaning they will display the same light shows only when connected to the same circuit.
The spa light may not be working due to improper installation, power not being switched “on” at the circuit breaker or light switch, or failure to follow correct wiring procedures. It is also important to ensure the light is submerged in water during operation, as running it dry can cause the light to shut down or become damaged.
This answer is automatically generated