Setting Up A Stacked Configuration; Rack Mounting Stacked Configurations; Cabling Stacked Configurations; Redundant Stacking Cable Connections - Alcatel-Lucent OmniSwitch 6850 Series Hardware User's Manual

OmniSwitch 6850 Series Chassis and Hardware Components

Setting Up a Stacked Configuration

Rack Mounting Stacked Configurations

To rack mount a stacked configuration, install all switches that are to be included in the stacked configura-
tion as described on pages
chassis.
Note. You cannot mix OS6800 and OS6850 switches in a stack.
Note. When rack mounting multiple switches in a stacked configuration, be sure to place all switches in
vertically-adjacent rack positions. This will ensure that all required stacking cables will have adequate
length for the installation.

Cabling Stacked Configurations

In order to connect stacked switches into a virtual chassis, all modules in the stack must be connected via
stacking cables (provided).

Redundant Stacking Cable Connections

In addition to the stacking cables installed between adjacent switch, the top-most switch and bottom-most
switch in the stack must be connected using a redundant stacking cable. Refer to
OmniSwitch 6850 Series Stacks"

Supported Cabling Patterns

Each switch provides two stacking: stacking port A and stacking port B. Cables can be connected in any
pattern. In other words, the cable connected to stacking port A of one switch can be connected to either
stacking port A or stacking port B of the adjacent switch. However, it is strongly recommended that the
cabling pattern remains consistent across the stack. For a cabling diagram and additional information on
cabling the stack, refer to
Cabling Steps
1 Before inserting a stacking cable into one of the stacking, be sure to orient the stacking cable connec-
tor properly. The wide portion of the connector must be facing up. Refer to the diagram below for more
information.
Connector Top
OmniSwitch 6850 Series Hardware Users Guide
2-61 through 2-62. Up to eight switches may be stacked to form a single virtual
for more information on the redundant stacking cable connection.
Chapter 4, "Managing OmniSwitch 6850 Series Stacks."
When orienting the stacking cable connector, be sure
that the wider portion of the connector is facing up as
shown. Otherwise, the stacking cable will not fit
properly in the chassis' stacking port.
End View of Stacking Cable Connector
August 2007
Setting Up a Stacked Configuration
Chapter 4, "Managing
page 2-63