Clean Up; Site Considerations - Grizzly G8622 Instruction Manual

Clean Up

The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship-
ment. Remove this protective coating with a sol-
vent cleaner or citrus-based degreaser such as
Grizzly's G7895 Degreaser. Avoid chlorine-
based solvents as they may damage painted sur-
faces should they come in contact. Always follow
the usage instructions on the product you choose
for clean up.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest-
ed. Always work in well-
ventilated areas far from
potential ignition sources
when dealing with sol-
vents. Use care when dis-
posing of waste rags and
towels to be sure they do
not create fire or environ-
mental hazards.
-10-
Do not use gasoline or
other petroleum-based
solvents to clean with.
They have low flash
points which make them
extremely flammable. A
risk of explosion and
burning exists if these
p r o d u c t s a r e u s e d .
Serious personal injury
may occur.
Do not smoke while using
solvents. A risk of explo-
sion or fire exists and may
result in serious personal
injury.

Site Considerations

FLOOR LOAD
Your Model G8622 Shaper represents a moder-
ately large weight load in a small footprint. Most
commercial shop floors will be adequate for the
770 lb. weight of the Model G8622. Some floors
may require additional support. Contact an archi-
tect or structural engineer if you have any ques-
tion about the ability of your floor to handle the
weight.
WORKING CLEARANCES
Working clearances can be thought of as the dis-
tances between machines and obstacles that
allow safe operation of every machine without
limitation. Consider existing and anticipated
machine needs, size of material to be processed
through each machine, and space for auxiliary
stands and/or work tables. Also consider the rel-
ative position of each machine to one another for
efficient material handling. Be sure to allow your-
self sufficient room to safely run your machines in
any foreseeable operation.
LIGHTING AND OUTLETS
Lighting should be bright enough to eliminate
shadow and prevent eye strain. Electrical circuits
should be dedicated or large enough to handle
combined motor amp loads. Outlets should be
located near each machine so power or exten-
sion cords are not obstructing high-traffic areas.
Be sure to observe local electrical codes for prop-
er installation of new lighting, outlets, or circuits.
Make your shop "child safe."
Ensure that your workplace
is inaccessible to children by
closing
entrances when you are
away. Never allow visitors in
your shop when assembling,
adjusting,
equipment.
G8622 Tilting Spindle Sliding Table Shaper
and locking all
or operating