Seat Adjustment And Seat Back Pad; Tools - Life Fitness LIFECYCLE R1 Owner's Manual

Hardware Bag #3
5mm Hex Head Wrench, Phillips Screwdriver, 13mm Socket Wrench
Align the guide rollers located on the underside of the SEAT ASSEMBLY (F) with the SEAT EXTRUSION (L). Carefully
guide the SEAT ASSEMBLY onto the SEAT EXTRUSION. Slide the SEAT ASSEMBLY fully forward. Connect the WIRE
(M) leading from the user left side of the SEAT ASSEMBLY to the JACK located at the left front of the SEAT EXTRU-
SION. Insert the WIRE (M) into the WIRE HARNESS (N) located next to the JACK.
Note
In the hole located on the user right side of the SEAT EXTRUSION (L), behind the SEAT ASSEMBLY (F), install one
40mm BUTTON HEAD SCREW WITH LOCKING COMPOUND (7), one 24mm FLAT WASHER (8), one RUBBER
BUMPER SLEEVE (9), one 1" RUBBER BUMPER (10) and one 18mm FLAT WASHER (3) as shown.
Mount the SEAT ADJUSTMENT LEVER (O) to the user right side of the SEAT ASSEMBLY (F) using two 12 mm
PHILLIPS SCREWS W/LOCKING COMPOUND (11). Tighten the SCREWS securely.
Note:
Locate the SEAT EXTRUSION ENDCAP (P). Secure the SEAT EXTRUSION ENDCAP to the SEAT EXTRUSION (L)
using two 12mm PHILLIPS SCREWS (12).
Secure the SEAT BACK PAD (Q) to the UPPER SEAT SUPPORT TUBES (R) using four 55mm PHILLIPS
SCREWS (4) and LOCK WASHERS (5). Tighten the SCREWS securely.
(1, 40mm Button Head Screw with Locking Compound)
(1, 24mm Flat Washer)
(1, Rubber Bumper Sleeve)
(1, Rubber Bumper 1")
(1, 18mm Flat Washer)
(2, 12mm Phillips Screws with Locking Compound)
(2, 12mm Phillips Screws)
(4, 55mm Phillips Screws)
(4, 8mm Nylock Nuts)
(4, 8mm Self-Tapping Phillips Screws)
(4, 12mm Phillips Screws)
11