Advertisement
Advertisement
Table of Contents
Related Manuals for TL Audio ITUBE 452
Summary of Contents for TL Audio ITUBE 452
- Page 1 USER MANUAL ENGLISH Amplifier 2 x 45Watt ® udio...
-
Page 2: Table Of Contents
..... . . Congratulations on your choice of the Fatman iTube 452 by TL Audio. We have used years of audio engineering experience to bring you a product that will truly enhance your listening experience. -
Page 3: Safety Instructions
Unplug the Read instructions: All safety and operating instructions iTube 452 when not in use for a long period. should be read thoroughly before attempting to operate Always make sure power cables are placed safely the Fatman iTube 452. -
Page 4: Amplifier Connection Diagram
Amplifier Connections Connections Left Sound Track is White Vacuum Tube / Transistor Pre-Amplfier Right Sound CD Player Track is Black • Before attempting to make any connections to or • Always turn OFF the power switches when from the unit, be sure to first switch OFF the power connecting or disconnecting from mains power. - Page 5 USER MANUAL ENGLISH Amplifier Connections • Connect using high quality, bare(stripped) speaker • When using bare speaker wires, fit at least 1.6mm of wire. Please note that if your speaker wires are not insulation inside the speaker terminals so that no connected properly you may hear no sound or if bare wire is visible.
-
Page 6: Front Panel Controls
- the speaker-protection circuit will mute the volume for a few seconds after power is switched ON. SOURCE - For selecting the different Signal Source. VOLUME CONTROL - To increase or decrease the volume. ATTENTION: Your iTube 452 should only be re-started 5 minutes after switching off, to avoid damaging the tubes. Audio... -
Page 7: Troubleshooting
Troubleshooting If your iTube 452 fails to operate normally, please check the following points to determine if the fault can be corrected with one of the simple suggestions below. If you feel your unit is still faulty after reading this, please contact your authorised dealer or service centre. -
Page 8: Maintenance
Specification • Max Output Power: 45Wx2 • Frequency Response: 20-20KHz (±1.0dB) • Distortion: ≤1% • Signal to Noise Ratio: ≥86dB • Input Sensitivity: 210mV • Input Impedance: 100KΩ • Output Impedance: 4Ω /8Ω • Size (LxWxH): 420mm x 265mm x 154mm •...
Need help?
Do you have a question about the ITUBE 452 and is the answer not in the manual?
Questions and answers